T9700(TM51D/E) MCB WIR
T9600HRT(COMFORT)/T960
T9200/T9250 MCB WIRING
SECTION 3 CONSO
T9700(TM51D/E) TREADM
KEY BEHALE FUNCTION
P13 ELV DIR Change th
T9600HRT(COMFORT)/T960
KEY BEHALE FUNCTION k
Appendix (1) SOU=SOU
TABLE OF CONTENTS
Metric
Remarks : 1. If set a
T9200/T9250 TREADMILLS
ENG1 Remarks: 1. If
SECTION 4 MC
MCB LED Indication N
MCB LED Indication
MCB LED Indication
PWM MCB LED CHART NO. AC +18V +11V MTR I-LIMIT PWM UP DN 1 OFF OFF OFF OFF OFF OFF OFF OFF 2 ON OFF OFF OFF OFF
MCB LED-AIDED TROUBLESHOOTING CHART NO. PROBLEM/RESULT CORRECTIVE ACTION 1 No operation of MCB or PCB Verify connect
SECTION 1 MAIN
SECTION 5 TROUBLESHOOTINGS
No display on console Possible causes: 1. Breaker is damaged. 2. ON/OFF switch is damaged. 3. MCB is damaged. 4. 6-p
Running speed is not stable Possible causes: 1. AC power voltage is too low. 2. Tension of drive belt or running belt is
Treadmill starts to run by itself Possible causes: 1. The console cable is broken. 2. PCB is out of order. 3. MCB is out
Noises generated under motor cover Possible causes: 1. The running belt tension is adjusted too tight. 2. The bearing of
Treadmill will not start Possible causes: 1. MCB is damaged. 2. 8-pin console cable is damaged. 3. PCB is damaged. 4.
Incline function does not work Possible causes: 1. The 8-pin console cable is damaged. 2. Incline motor is damaged. 3.
Heart-Rate-Control function does not work Possible causes: 1. Transmitter does not contact with user's chest very
Error Messages on the Console T9700 (TM51D/E) Error code definition Error Definition E4 Incline motor parameter
T9600HRT (COMFORT)/T9600HRT/T9500HRT/T9450HRT/T9350/T9300 Error code definition Error Definition E4 Incline motor par
PREVENTIVE MAINTENA
T9200/T9250 Error code definition Error code definition Error Definition E2 Incline motor problem Error Message &qu
Revision: 1.0 Date: 1999-09-01 SECTION 6 SOFTWARE UPGRADE PROCEDURE
Revision: 1.0 Date: 1999-09-01 VISION SERIES TREADMILL SOFTWARE UPGRADE SOP A. Service Tools & Accessories: 1
Revision: 1.0 Date: 1999-09-01 B. Steps: 2. Connection cables & short pin is ready. 3. Turn ON the power switch
TENSIONING THE BELT
DECK RE-WAXING PROCE
CLEAN THE GROOVES PR
LUBRICATING THE AIR
SECTION 2 WIRING D
Comments to this Manuals