Vision Fitness R44 Specifications download pdf (Page 20)

SECTION V

CONFIGURATION

WARNING

Property damage, serious injury, or

death to you or others may result if the

Vision warning system is improperly

conﬁgured. Conﬁguration, if required,

is to be performed at the time of instal-

lation. It is NOT intended for operators

to “customize” the Vision’s operation

for their individual preferences. It is

the USER’s responsibility to determine

compatibility, suitability, and ensure

proper conﬁguration of the Vision warn-

ing system.

The person responsible for conﬁguration

MUST be familiar with local codes and

procedures for safe emergency vehicle

warning system operation.

CONFIGURATION INSTRUCTIONS

The Premium Vision is an extremely versatile

and conﬁgurable warning system. Take-down lights,

alley lights, secondary and primary warning light

patterns, siren functions, and the optional Signal-

Master directional warning signals are all available

with the “standard” keyboard conﬁgurations. Also,

control of auxiliary devices (headlight ﬂashers, grille

lights, etc.) is available.

For conﬁguration instructions, refer to the sup-

plied Operation and Conﬁguration Instructions.

5-1. USER FIELD-PROGRAMMABLE FUNCTIONS.

See ﬁgure 5-1. There are three lightbar functions

that can be programmed by the user, via two switches

located in POD 1. The red ON/OFF switch is ON

when the pushbutton is in, OFF when the pushbut-

ton is out.

5-2. LED FLASH PATTERNS.

There are six available LED ﬂash patterns:

• Random

• Quad Flash alternating 75FPM

• Single Flash alternating 75FPM

• Alternate Flash POD’s 1&7 90FPM rear

only

• Alternate Flash POD’s 1&7 90FPM front

and rear

• Alternate Flash POD’s 1&7 with POD 4

90FPM rear only

Three default patterns are assigned to operate

in slide switch positions 1, 2, and 3. They are as fol-

lows:

• Slide Switch Position #1 – Single ﬂash

• Slide Switch Position #2 – Quad ﬂash

• Slide Switch Position #3 – Random

To change a ﬂash pattern assigned to a slide

switch perform the following:

A. Remove POD #1 dome.

B. Activate the lightbar in the desired slide

switch position. The bar will ﬂash in the current pat-

tern.

C. Depress the white momentary switch. The

LED ﬂash pattern will advance to the next available

pattern and the end LED module in POD #1 will

ﬂash the pattern number. The lightbar will stop mo-

mentarily, then operate in the selected pattern. Each

time the white pushbutton is depressed the pattern

number will advance. When the last available pattern

number is reached the next operation of the switch

will select the ﬁrst available pattern.

D. If patterns assigned to the other slide

switch positions are to be changed, position the slide

switch to the desired position and repeat the above

steps.

E. Reinstall POD #1 dome.

290A5276-14

MOMENTARY

SWITCH

RED ON/OFF

SWITCH

Figure 5-1.

5-1

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comments to this Manuals

No comments

Vision Fitness R44 Specifications Page 20

Comments to this Manuals

Related products and manuals for Bicycles Vision Fitness R44