Vision Fitness R44 Specifications download pdf (Page 24)

SECTION VI

SERVICE AND MAINTENANCE

SAFETY MESSAGE TO PERSONNEL SERVICING

FEDERAL SIGNAL WARNING SYSTEMS

WARNING

The lives of people depend on your safe

servicing of Federal products. It is impor-

tant to read and follow all instructions

shipped with the products. In addition,

listed below are some other safety instruc-

tions and precautions you should follow:

• Read and understand all instructions in this

manual before servicing electronic siren.

• To properly service a warning system: you

must have a good understanding of automo-

tive electrical procedures and systems, along

with proﬁciency in the installation and

service of safety warning equipment.

• Electronic circuit repairs must be performed

by a qualiﬁed and competent electronic

technician.

• Your hearing and the hearing of others, in

or close to your emergency vehicle, could

be damaged by loud sounds. This can occur

from short exposures to very loud sounds,

or from longer exposures to moderately loud

sounds. For hearing conservation guidance,

refer to federal, state, or local recommenda-

tions. OSHA Standard 1910.95 offers guid-

ance on “Permissible Noise Exposure.”

• All effective sirens and horns produce loud

sounds which may cause, in certain situa-

tions, permanent hearing loss. You should

take appropriate safety precautions such as

wearing hearing protection.

• This product contains high intensity LED

devices. To prevent permanent eye damage,

DO NOT stare into the light beam at close

range.

• DO NOT connect this system to the positive

terminal of the battery until servicing is

complete, and you have veriﬁed that there

are no short circuits to ground.

• In order for the warning system to function

properly, the ground connection must be

made to the NEGATIVE battery terminal.

• After repair, test the complete warning sys-

tem to ensure that it is operating properly.

Failure to follow all safety precautions and

instructions may result in property damage, seri-

ous injury, or death to you or others.

6-1. GENERAL.

Most of the component electronic parts used in

the Premium Vision SL are standard items that can

be obtained from any TV or electronics shop. In order

to reduce equipment down-time, Federal recommends

that an entire printed circuit board be replaced. The

printed circuit boards are relatively inexpensive al-

lowing you to keep an adequate supply in your repair

shop.

For warranty service, contact your local Distrib-

utor.

The factory can and will service your equipment

or assist you with technical problems that cannot be

handled satisfactorily and promptly locally.

Communications and shipments should be ad-

dressed to:

Service Department

Federal Signal Corporation

2645 Federal Signal Drive

University Park, IL 60466

1-800-433-9132

(In Illinois) 708-534-3400

6-2. CONTROL HEAD.

The Premium Vision SL control head consists of

two circuit boards stacked on top of each other. See

ﬁgure 6-1. To disassemble the control head, proceed

as follows:

A. Disconnect the control head cable at the

control head. Remove the control head from its

bracket (if used).

B. Remove and retain the four screws from the

rear of the control head. Separate the control head

rear housing (base) from the bezel. Lift the keyboard

assembly out through the bezel.

C. Separate the two circuit boards by gently

pulling them apart.

D. Disconnect the green wire at the stud on

the keypad circuit board.

E. Observe the slide switch connector’s orien-

tation and then disconnect the slide switch connector.

F. After repair or replacement, reconnect the

green wire and slide switch connector. Ensure the

6-1

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Vision Fitness R44 Specifications Page 24

Comments to this Manuals

Related products and manuals for Bicycles Vision Fitness R44