40
7.12 GENERATOR REPLACEMENT - CONTINUED
CHAPTER 7: PART REPLACEMENT GUIDE
FIGURE K
9) Once the generator belt is removed from around the pulley on the secondary pulley assembly, the generator can be pulled towards the front
of the unit so that the generator belt can be removed from around the generator pulley (Figure I).
10) Unplug the generator wire and cut any wire ties holding the generator wire to the frame (Figure J).
11) Once the generator belt is removed from the generator pulley and the generator wire is unplugged, the generator can be removed from the
front end of the frame (Figure K).
12) Reverse Steps 1-11 to install a new generator. NOTE: Be sure to tension the new generator belt so that it can be twisted a maximum of
45 degrees (Figure L).
13) Test the bike for function as outlined in Section 7.14.
FIGURE JFIGURE I
FIGURE L
Comments to this Manuals