Vision Fitness T9600HRT Comfort User Manual download pdf (Page 34)

GENERAL

AUTO-CALIBRATION

(Models T9300HRT/T9500HRT/T9500HRT Ortho/T9600HRT Comfort Only)

DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION!

Auto-calibration is not represented by a Px designation. "Auto" appears in

the center window. When you enter the function, "Auto" begins flashing.

To begin auto-calibration, press START. The treadmill will run through

minimum and maximum speed and maximum incline, this will take three to

five minutes. Let the treadmill perform this complete function before exiting

the Engineering Mode.

Elevation A/D or Elevation in % appears in the left window. PWM value

or Speed appears in the right window. "End" will appear in the center

window when the auto-calibration is complete. When auto-calibration is

complete, it will take about 30 seconds to go to 0 elevation and return to

the start-up screen with P1 showing in the function window.

EXIT USER ENGINEERING MODE

P14 represents exit mode. When you press START to select the function,

the console performs a reboot, returning to program setup.

AUTO CALIBRATION

(Model T9200 Only)

DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION

Hold the Elevation Up and Speed Down buttons for 5 seconds. The

console will beep 5 times and a number will appear in the window.

Shortly thereafter, EnG1 will appear in the window.

Press the Elevation Up or Speed Up to EnG4

Press Start. The treadmill will calibrate itself. It will take 3-5 minutes. When

the Auto Calibration is complete "END" will flash in the window. Wait 10

seconds.

Remove the Safety Key, then put the Safety Key in place to use the treadmill.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

No comments

Vision Fitness T9600HRT Comfort User Manual Page 34